Skip to main content

Android Phones - Hard Reset

 Android Phones - Hard Reset
Please post here only Hard Reset of Android Phones
No question or how to please.

Help me to keep this thread clean

A big thanks to www.hard-reset.eu for their resource

"Performing a factory data reset deletes all data, including downloaded applications, and resets the device back to its initial state—the state before you turned on the device for the first time.
Important Make sure to back up important data you have on the device before you perform a factory data reset."

HTC Dream
1. Turn the G1 off. If it’s frozen on, take the battery out and put it back in the unit.

2. Hold the Home and Power keys down at same time for about 25 seconds. You will see a yellow triangle screen with exclamation point in the
middle.

Now to wipe the device clean:

3. Press Alt+L.
4. Press Alt+W for a factory reset.
5. Press the Home and Back keys again for about 25 seconds.
The device should then reset again and the hard reset is complete.

++++++++++++++++++++++++++++++++++++++++++++++++++

HTC Magic

1. With the phone turned off, press and hold the HOME and BACK
2. Briefly press the END CALL/POWER button while continuing to pressHOME and BACK buttons.
3. When you see the screen with the 3 Android images, release the HOME and BACK buttons, and then press the TRACKBALL.

Tip
: If your phone hangs or freezes, remove the battery then wait for a few seconds, and then re-install it. After re-installing the battery, turn on the phone.


++++++++++++++++++++++++++++++++++++++++++++++++++

HTC Hero

1. With the phone turned off, press and hold the HOME and BACKand then briefly press the END CALL/POWER button. The reset process will start after a few seconds.
2. Wait for the phone to finish the reset process and then press MENU.

Tip : If your phone hangs or freezes, remove the battery then wait for a few seconds, and then re-install it. After re-installing the battery, turn on the phone.

++++++++++++++++++++++++++++++++++++++++++++++++++

HTC Tattoo

1. With the phone turned off, press and hold the HOME and BACKand then briefly press the END CALL/POWER button.
2. Press the ENTER button to begin the reset process.

Tip If your phone hangs or freezes, remove the battery then wait for a few seconds, and then re-install it. After re-installing the battery, turn on the phone.

++++++++++++++++++++++++++++++++++++++++++++++++++

HTC Desire
: reserved

++++++++++++++++++++++++++++++++++++++++++++++++++

HTC Whitestone :
reserved

++++++++++++++++++++++++++++++++++++++++++++++++++



Motorola Droid

To reset your phone to factory settings and erase all the data on your phone,
Touch Menu > Settings
> Privacy > Factory data reset > Reset phone.
Warning: All data on your phone will be deleted.

Motorola Droid Hard reset with keys

Power off device.
Press X key on hard keyboard + power button, then release both buttons.

When you see exclamation point press and hold VOLUME UP + CAMERA KEY. You will see Android system recovery menu.
With D pad go to data / factory reset, then press CENTER D Pad, then choose Yes.
++++++++++++++++++++++++++++++++++++++++++++++++++

Motorola Dext : Reserved

++++++++++++++++++++++++++++++++++++++++++++++++++



LG GW620 [Eve] Hard Reset

To do a hard reset or data reset in LG GW620 aka EVE

Enter using Dial pad

3845#*620#

From menu select factory reset or whatever you want.

++++++++++++++++++++++++++++++++++++++++++++++++++


HTC Dream Soft reset



A soft reset clears the device memory and closes running applications. Perform a soft reset when your device hangs or freezes, is running slower than normal, or an application is not performing properly. If a soft reset is performed when applications are running, unsaved information will be lost.
To perform a soft reset
1. Remove the back cover.
2. Remove the battery for a few seconds.
3. Re-install the battery, replace the back cover, then turn on the device

To remove the back cover
1. Make sure the device is turned off.
2. Hold the device sideways with the control buttons on the right.
3. Slide the screen panel up to reveal the keyboard and the back cover release tab.
4. Gently push down the release tab with your finger until the back cover disengages from the device.
5. Pull the back cover out then set it aside.


 Motorola Dext

factory reset

1. Holding the Camera button while turning on your phone,
2. When prompted hit the Volume-Down rocker button to go into Recovery Mode.
3. After you get into Recovery Mode,
4. Press ALT+L to reset, then Menu+Back to reboot.

HTC Droid Eris Hard Reset

Perform a hard reset on your HTC Droid Eris. These steps will clear all data and settings off the device.
1. With the phone turned off, press and hold the Volume Down and Send buttons.
2. Press the Power button.
3. Follow the instructions to complete the hard reset.



Please post comments to improove my work and also learn how to work.
Bookmark this page for more useful stuff. CTRL+D
always check Archives on the side bar for old posts.

Comments

Popular posts from this blog

E52 Shut off,contact retailer and memory full Solution tested

Hi, I am sharing here success story with E52.which i got with  memory full, auto shut off after startup and contact retailer fault. Solution! Just flash with latest flash files with mx key also don't forget to FULL FACTORY, USER DATA and file system formatting    Here is full log. [BB5,XSR 1.6]  size: 38.65 MB  Supported Ids: 4003192102001104, 400C192102001104, 6003192102001104, 600C192102001104, 6003192102011104, 600C192102011104, 6003192102021104, 600C192102021104, 600C192102031104, 6003192102031104 Erase size: 41.75 MB CMT MuxOneNAND area [07340000-09CFFFFF] Flash programming ... Programming completed in 8.140 s Processing PPM file: rm469_052.003_C00.01_DEFAULT_prd.rofs3.fpsx  [BB5,XSR 1.6]  size: 7.55 MB  Supported Ids: 4003192102001104, 400C192102001104, 6003192102001104, 600C192102001104, 6003192102011104, 600C192102011104, 6003192102021104, 600C192102021104, 600C192102031104, 6003192102031104 Erase size: 20.25 MB CMT MuxOneNAND area [09D00000-0B13FFFF]

Nokia 1203 1203 1661 torch light solution

Nokia 1202 1203 1661 Torch light solution just check marked resistance if ok connect it to torch light led leg. and second point is going to  B+ so check it also. Enjoy!

HWK Dongle Tutorial

HELLO FRIENDS I AM POSTING HERE COMPLETE TUTORIAL HOW TO REPROGRAM DEAD HWK  AND ALL OTHER TEXAS INSTRUMENTS  MSP430 SERIES MCU,S THIS TUTORIAL IS SPECIALLY FOR MSP430F1121A WHICH USED IN HWK CHIP LETS START. WHAT WE NEED TO DO THIS? (1)  DEAD HWK  (2)  HWK HEX FILE. (3)  MSP FET THAT IS A FREE PROGRAM (4)  HWK REPAIR DONGLE OR ANY OTHER INTERFACE JTAG OR BSL. NOW OPEN UFS BOX AND GET DEAD HWK FROM BOX AND CONNECT TO HWK REPAIR NOW CONNECT DONGLE IN PC USB PORT . IF YOUR COMPUTER HAVE ALREADY PL2303 DRIVERS INSTALLED DONGLE WILL MAKE USB TO SERIAL PORT IF YOU DON'T HAVE INSTALLED DRIVERS PL2303 THEN GIVE DRIVER PATH AND AFTER COMPLETE THIS PROCESS YOU WILL GET USB TO SERIAL PORT. NOW OPEN MSP FET PROGRAM AND CLICK ON SETUP MAKE SETTING CURRENT ADAPTER SETTING  AND SELECT BSL  AND BLOW SELECT YOU COM PORT NO. OTHER SETTING CHANGE LIKE VIDEO.NOW SELECT YOUR MCU NO HERE WE ARE WORKING ON MSP430F1121A SO SELECT THE MSP430F1121A ENJOY! WILL COME BACK SOON WITH NEW USEFUL